3D Printing Notes Revision as of Sunday, 23 June 2024 at 19:22 UTC
For a lovely little Prusa Mini+ ❤️
Assorted Notes
- Z-axis does not go higher than 145mm
- If you are not using your the printer, unload the filament, park it and COVER it. Keep the filament in a sealed plastic bag! Dust is an enemy.
- After a while, lube the printer’s arms. Don’t overdo it. A little dab is enough. Sewing oil works fine if you run out of the supplied Prusa paste.
Nozzle Offset
In addition to the bed’s flatness, this is a good culprit for shitprints. Right now, I’m rocking -1.128.
- Top: Adjusted the height as it was printing.
- Middle: This led to shit results… height was not small enough.
- Bottom: Ideal height 🥲
Resources
3d Models
- (Resource) https://www.thingiverse.com/
- (Resource) https://www.printables.com/
- (Resource) https://thangs.com/
- (Resource) https://www.tinkercad.com/things
- (Model) https://www.multiboard.io/
- (Model) UniFi Mini Rack. Here’s another model.