FreeNAS Notes Revision as of Sunday, 20 December 2015 at 19:56 UTC

__NOTOC__

Notes

• Drives from the same manufacturing batches are prone to
  fail together. This is bad. So purchase drives from separate
  websites/vendors to mix things up.
• Be careful with SATA port
  multipliers.
• Storage is cheap, and RAIDZ2 is the way to go.
• Picking components is essentially a balancing act of these factors:
  • Low power and/or small form-factor
  • High capacity
  • High redundancy
  • High performance
  • Low $$$
  • Expandability
• Used FreeNAS 8.3
• SMB was significantly slower than AFP.
• Wrote a small
  script to snapshot
  my Macs from the FreeNAS box. Did this by creating a new account,
  setting the home folder in a ZFS filesystem, generating SSH keys,
  putting them on Macs.
  • Runs as a cron job at midnight
  • Script needs full paths to zfs, sudo, rsync, etc.

Gigabyte USB Boot Issues

BIOS would ‘forget’ boot order. Configured USB stick as hard drive.
Problem solved by upgrading from F1 to
F3.

FreeNAS Upgrade

Downloaded GUI upgrade
for v9.2 (x86-64). Backed up config, then applied.

Got the dreaded “Mounting failed with error
19”
message no matter what I tried in BIOS (disabling XHCI, etc.) Plugging
USB stick into a 2.0 port seemed to work. ZFS volume upgrade was quick
and painless.

Hardware

I didn’t care about size. Also wanted a mobo that has as many onboard
SATA ports as possible. Lots of memory since ZFS loves
memory.

• Used nylon 8-32 × ½ Phillips flat-head screws for the fan-filters.

Software

• Mounting:

 # Mount read-write
 mount -wu /
 
 # Mount read-only
 mount -ru /

• Sudoers file is at /conf/base/etc/local/sudoers. You will lose
  changes to this file upon upgrading FreeNAS.

References

• http://blog.brianmoses.net/2013/01/diy-nas-2013-edition.html

Category: Nikhil’s Notes
Category: Installation Logs
Category: FreeNAS